High Quality Wood Floor Sealant, Timber Floor Sealant, Timber Floor Suppliers in China

Home > Products > Waterproof Coating > PU Waterproof Coating (JOT66)

PU Waterproof Coating (JOT66)

Product Description



Trademark: pustar




Origin: Dongguan, China


PU Waterproof Coating (JOT99)



1. TECHNICAL DATA SHEET:

Testing Items Performance

Appearance Red\Green\Gray\White\Black, etc.

Method of application(mm) Self-leveling

Tensile strength(MPA) ≥ 4

Elongation at break(%) ≥ 700

Tear strength(N/mm) ≥ 14

Tear propagation resistance (MPA) ≥ 1.5

Low-temperature bending ≤ -35

Waterproofness(0.3 MPA 30min) good

Solid content/(% ) ≥ 98

Tack free time(h ) ≤ 1

Full cure time(/h) ≤ 24

Hardness/A 55± 5

Shelf life(month) 9



Note:

All data above ware tested under standardized condition.

All data listed in the chart were series; Please refer to the related datasheet for special items.

Storage condition has a direct impact to the products' shelf life, Please refer to the instruction for special items' storing.



2. DESCRIPTION:

Jot99 is is a kind of coating made by pure polyurea. It is applied on substrates, to form a firm, soft, seamless sealing film by chemical reaction with moisture in the air. Jot99 is manufactured in accordance with the GB/T19250-2003.



3. USES:

Suitable for waterproofing of superior grade houses'roof, basement, kitchen room and bathe room.

Suitable for waterproofing and moisture-proofing of buildings, stadiums, sewage pond and swimming poll and so on.



4. ClEANING:

Clean and dry all surfaces by removing foreign matter and contaminants such as oil dust, grease, frost, water, dirt, old sealants and any protective coating. Dust and loose particles should be cleaned.



5. PACKAGING:

700g sausage\20kg/bucket



6. APPLICATION:

The substrate should be smooth, solid, clean, dry without Sharp concave and convex points, honeycomb, pocking marks, peeling, free of bulges, greasy before application. It is better coating 3 times with scraper. When the first coat isn't sticky, the second coat can be applied, the first layer is recommended being applied in thinner layer for better releasing gas generated during reaction. The second coat should be applied in different direction to the first coat. The optimal coating rate is 2.0kg/m² For thickness of 1.5mm.



7. ADVANTAGES:

* Can be made into many kinds of colour.

* Contains no asphalt, tar or any solvents, no harm to constructer.

* Easy for applying.

* Free from pollution to the environment, No toxity after curing, No corrosion to base material, High solid content.

* One component, convenient for construction, No need of mixing.



8. ADVICE:

* Jot99 should be inverted in dry and shady indoor, avoid sunlight and moisture.

* It is normally that a film formed on the surface of coating. It can be used normally when removing the film.

* The rest coating should be sealed in order to avoid moisture.

* Pay attention to protect the waterproofing membrane during constructing period and after finished.

* Warehouses and construction of the site is strictly prohibited fireworks.

Contact us if you need more details on Pu Coating. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Coating、Polyurethane Coating. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Waterproof Coating

Email to this supplier
  • *Subject:
  • To:

  • *Messages:
    Your message must be between 20-8000 characters

Premium Related Products